My mom's door seems to have shifted a little to where she could not close the dead bolt. I went out and put 3 x 3" screws into the top hinge plate to pull it up some.
While she can close it now, it clips the bottom of the striker plate and now there is a gap at the top.
The bottom of the door seals well.
The top part of the door actually is about 1/8" past the door opening now.
Does anyone have any suggestions for fixing this? I see a couple of issues but I'm not sure how to address them.
While she can close it now, it clips the bottom of the striker plate and now there is a gap at the top.
The bottom of the door seals well.
The top part of the door actually is about 1/8" past the door opening now.
Does anyone have any suggestions for fixing this? I see a couple of issues but I'm not sure how to address them.
Comment