View Single Post
Old 03-15-2021, 11:52 AM   #2
wellingtontx
Pope & Young
 
wellingtontx's Avatar
 
Join Date: Feb 2009
Hunt In: Collingsworth County, Texas
Default

Then to the remake.

Cleaned the drive shaft up and replaced the broken wheel.

Got the new ends back from the shop. First install realized my drive shaft was a little short for the new design so had to turn the ends around. I anticipated that this might be the case, so no problem - after a couple of new drill bits and a lot of muscle. Add a couple of trips to Tractor Supply for new grade 8 bolts.

Ordered some collar shafts to keep the wheel shaft from moving from side-to-side off of Amazon.

End bearings off of Amazon as well.

Name:  CP13.jpg
Views: 546
Size:  88.9 KB

Name:  CP14.jpg
Views: 549
Size:  79.3 KB

Name:  CP15.jpg
Views: 552
Size:  74.9 KB

Name:  CP16.jpg
Views: 547
Size:  89.0 KB

Name:  CP17.jpg
Views: 546
Size:  110.1 KB

Name:  CP18.jpg
Views: 542
Size:  115.0 KB

Name:  CP19.jpg
Views: 545
Size:  104.2 KB

Name:  CP23.jpg
Views: 544
Size:  156.5 KB

Last edited by wellingtontx; 03-15-2021 at 11:58 AM.
wellingtontx is offline   Reply With Quote Back To The Top