I've been waiting to see what APR is going to introduce. I'm looking at the same cartridge for a new rifle. Hoping to find a case of Fed215 primers somewhere.
I've been waiting to see what APR is going to introduce. I'm looking at the same cartridge for a new rifle. Hoping to find a case of Fed215 primers somewhere.
Scheels in the colony had a few bricks last time I went in. Didn’t need any but did put up some CCI 450s
I've been waiting to see what APR is going to introduce. I'm looking at the same cartridge for a new rifle. Hoping to find a case of Fed215 primers somewhere.
The 300 PRC has been a dream to shoot. I would change a few things now that it’s done. One being the stock bc I don’t really like the palm swell. I may swap later on for an ultra lite chassis that’s about the same weight as my manners eh1. I would maybe use a different action that has a full 20 moa integrated rail and not what I have so I can adjust my scope further back but it’s so close as is I’m not worried. And maybe go a different route in optics for a 34 mm tube and not 30 bc the eye box is finicky at times in an uncomfortable shooting position. All very minor gripes.
I have less than 90 rounds down the tube and haven’t even tried fine tuning my loads. With virgin brass i shot 3 in a group well within a Copenhagen can at 500 and had a 3 shot group at 1000 that was about 9 inches. 2 hits were within 4” and the third was low but I’ll contribute that to 23 fps slower than the first two. A minor inconsistency I’m sure in the brass.
At the end of the day, it’s a 9.5 pound long range killing stick and steel plinker and I’m happy!
Comment