Announcement

Collapse
No announcement yet.

All Season Feeder Repair Ideas

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    All Season Feeder Repair Ideas

    Looking for some ideas on the best way to repair this feeder. One of the stubs broke off that the legs fits over. It’s 1” angle iron. Issue is I don’t have a welder or know how to weld.

    I was thinking of getting some of the angle iron with bolt holes in it but the smallest they seem to make is 1 1/4”. I’m just not sure the legs will fit over angle iron that size.

    Any other ideas?




    Sent from my iPhone using Tapatalk Pro
    Tags: None
    #2
    Do that and get new legs that are heavier sidewall

    Comment

      #3
      1/4”large Fender washers inside and out along with some silicone
      Straighten out side as good as possible,hammer and 2x4

      Comment

        #4
        Do you still have the piece that broke off? If so, and the feeder is in Kingwood, I'd be glad to weld it up for ya. I'm out near Cleveland. You can throw it in the back of your truck and bring it out, or if you can come to my office in Humble during the week, I can do it there...
        PM me if that will work for you.

        Comment

          #5
          3/4" coldroll or solid round rod. Heat and Bend at the same angle as the other bracket. Grind galvanize off old bracket and weld new round rod bracket to old angle iron bracket. If your around Caldwell or College Station PM me I'll fix it for you.
          Last edited by Johnson; 08-01-2021, 07:28 AM.

          Comment

          Previous template Next
          Working...
          X