2010 Elite Judge
Carbon Tech Cheetahs 55/80-300s (I’ve been shooting these for 5+ years)
100 grain field points (broadheads as well)
Spot Hogg Saturday Night Special release.
I shot for the first time in months today and was shooting field points to right of bullseye. The Copper John sight is adjusted as far as it goes towards the riser. So, I adjusted my Ripcord Code Red rest a little left. Arrows hitting now where I’m aiming now.
I shot a bare shaft a few times to compare, and it’s hitting 5 inches left, entering at angle with nock to right of the tip.
To move the rest to the right (to correct bare shaft results) , my pin will need to move right- but it’s max adjusted.
One solution would be to put washers between the sight and riser to gain some adjustment distance.
Another would be to change arrows/ tips and broadheads. Not what I want to do.
A third is to bring it to the pro shop who tuned it the last time (nicely done) and say “tune it again, Sam”.
Any other ideas?
Sent from my iPhone using Tapatalk
Carbon Tech Cheetahs 55/80-300s (I’ve been shooting these for 5+ years)
100 grain field points (broadheads as well)
Spot Hogg Saturday Night Special release.
I shot for the first time in months today and was shooting field points to right of bullseye. The Copper John sight is adjusted as far as it goes towards the riser. So, I adjusted my Ripcord Code Red rest a little left. Arrows hitting now where I’m aiming now.
I shot a bare shaft a few times to compare, and it’s hitting 5 inches left, entering at angle with nock to right of the tip.
To move the rest to the right (to correct bare shaft results) , my pin will need to move right- but it’s max adjusted.
One solution would be to put washers between the sight and riser to gain some adjustment distance.
Another would be to change arrows/ tips and broadheads. Not what I want to do.
A third is to bring it to the pro shop who tuned it the last time (nicely done) and say “tune it again, Sam”.
Any other ideas?
Sent from my iPhone using Tapatalk
Comment