![]() |
![]() |
![]() |
![]() |
![]() |
#1 |
Ten Point
Join Date: Dec 2010
Location: Blanco, TX
Hunt In: Draw Hunts
|
![]()
I've got a 5.0 that has stalled three times on acceleration and starts throwing all sorts of messages. Low oil, stability control, 911, etc. I've replaced the oil and installed a new battery, but it stranded me again today. Basically, the only way to reset it is to disconnect the battery and wait 30mins. I've done the fuel pump fuse upgrade, but that is it. I just drive it and do the maintenance on it.
Any clues? |
![]() |
![]() ![]() |
![]() |
#2 |
Pope & Young
![]() Join Date: Jun 2013
Location: Troup
Hunt In: Cherokee, Rusk Counties
|
![]()
I had a 2013 with a 5.0 that did that. It was the mass air sensor located in the air filter housing. Changed it out, no more trouble.
|
![]() |
![]() ![]() |
![]() |
#3 |
Ten Point
Join Date: Feb 2017
Location: Austin. Jim Ned Creek
Hunt In: Tivydale. Nix. Brownwood
|
![]()
Scan it for codes. Make sure the pipe from intake to sensor is sound and secure
|
![]() |
![]() ![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|