Announcement
Collapse
No announcement yet.
How to unstick a neutral bar screw?
Collapse
X
-
Originally posted by quarterback View PostJust sayin....
Comment
-
You also want to get the ground wires off your neutral bar and on to the ground bar.
Get a good screwdriver, set it in there and give it a few good wacks on the top of the shaft into the crew, penetrating oil cannot hurt, now be careful...other wires might be loose. If you do not do this for a living, shut down the power and check all connections, before giving a few good wacks. It can even blow up on a experienced guy, but he will have went through the process needed before, to make sure he can do that.
Comment
-
Originally posted by SaltwaterSlick View PostThis and an impact screwdriver... short of that, you'll have to drill it out. Looks like you have an aluminum wire in an aluminum bar and it's been wet/damp... not good... likely got a little corrosion going on there and it's frozen up good...
But it may be corrosion
Good luck is best I got
Comment
Comment