I just bought a NF Atacr 5-25x56 34mm tube. What size rings do I need?
Medium 1.00” or high 1.125” high
Medium 1.00” or high 1.125” high
-
-
Lows will work on most guns.
Rail? Barrel contour? -
This is lows with the 50mm
Sent from my iPhone using TapatalkComment
-
Based on that photo you should be able to clear a 56mm bell with the same height rings. That's a 30mm and the ATACR is 34mm though. I have a set of Warne Mtn Tech highs if you are interested, but I would try to stick with lows/mediums. Measure the clearance you'll need then buy the rings.Comment
-
Atacr is 34mm. I’ve ran several of them with lows. It’ll workOriginally posted by HUNTIN HARD View PostComment
-
On a 20MOA base I use the 1.0 inch.Comment
-
1.0 inch. 20moa base, ATACR 7-35. M24 contour barrel.
Sent from my SM-G975U using TapatalkLast edited by -HIC-; 09-10-2020, 08:35 AM.Comment
-
I have these gathering dust. If you need them shoot me an offer.
Sent from my SM-G975U using TapatalkComment
-
Wow ok thanks for info thought for sure I would need highs.Comment
-
Originally posted by HUNTIN HARD View Post
I’m not a mathematician (or even remotely good at math) but I believe you will only realize an additional 3mm on the bottom of the bell from your 50mm objective.Comment
-
-
You did better than me figuring that out. LolOriginally posted by kae006 View Post
Thanks againComment
-
My 56mm kahles in lows says otherwiseOriginally posted by TX03RUBI View Post
Barrel contour looks #5ish. Clears my medium Palma.Comment
-
Which brand rings?Originally posted by trophy8 View PostMy 56mm kahles in lows says otherwise
Barrel contour looks #5ish. Clears my medium Palma.Comment
-
So we just settled this on text haha Trophy8 is running NF 34mm Lows, which are 1.0” high. Most everyone else’s lows are between .88-.94, and 1.0s are usually considered a medium. Just clarifying thatOriginally posted by trophy8 View PostMy 56mm kahles in lows says otherwise
Barrel contour looks #5ish. Clears my medium Palma.
Comment
Comment