Form 1 question

[Witchgrass]

I’ve got a can that I need to get engraved, prior to finishing. It’s a titanium tube. Should is leave it unpainted? If I ceracoat it afterwards, will it hurt the engraving? Not really sure which way I want to go yet. Just need to get it finished. It got put on the shelf a while back due to more urgent issues.

[Raider4044]

I’ve got a can that I need to get engraved, prior to finishing. It’s a titanium tube. Should is leave it unpainted? If I ceracoat it afterwards, will it hurt the engraving? Not really sure which way I want to go yet. Just need to get it finished. It got put on the shelf a while back due to more urgent issues.

Mine was engraved before cerakote. As long as the engraving is deep enough and the cerakote isn't too terribly thick, you should be fine.

[ahlongslide]

Either is fine. Cerakote is super thin. Just tell the engraver to go a hair deeper than required.

[bermise]

There is a required minimum depth on the finished engraving. U may wanna look into that