I need a pressure autoclave that can heat something up to 250 degrees at 30-40psi. Needs to be about 2 foot in diameter and 3 feet long. I have googled til my fingers are bleeding and can't find what I am looking for. Anyone have any leads on this type of device? I am looking into both paying someone to do a few tests for me on some carbon composite layups as well as possibly buying one for us to use.
Announcement
Collapse
No announcement yet.
Pressure Autoclave??
Collapse
X
-
I'm in the composites business but we don't use an Autoclave for our process so we don't have one. Your best bet in going to be to find a company to process your parts for you as composite autoclaves are extremely expensive. You might try General Plastics & Composites LP 713-644-1449 to see if they could do something for you.
If you panels can be built without autoclave pressure and you can get by with just vacuum we might could help you out. We run carbon fiber epoxy pre-preg on all of our stuff.
Comment
Comment