T Posts without spade/kickplate

[frios]

Does anyone know where I can buy T Posts without the spade or kickplate?

I don't want to remove the spade on about 200 t posts either, so please don't tell me to remove it with hammer and a chisel.

I gotta believe someone sells them somewhere.

Thanks in advance.

[TXBRASS]

Have never seen them sold like that. We needed some for driving in rocky ground and ended up cutting rebar at a sharp angle and used that. It worked.

[BrianL]

Check your local farm co-op. or an air chisel

[ballgame]

Have never seen them sold like that. We needed some for driving in rocky ground and ended up cutting rebar at a sharp angle and used that. It worked.

This ^^^

[DirtyDave]

Just install them upside down.....

[Ohio Darin]

Search for unpainted T-posts. They don't usually have the kick plate. They are out there - just depends if in your area.

[Guest]

We just busy those plates off with a hand held sledge hammer while we vice grip it to the trailer or just use a grinder and cut of the teeth that hold it on

[frios]

Just install them upside down.....

Ha!

[BTLowry]

Go to the source

Find out who makes t-posts and see if they will run 200 for you without the spade

At least that is what I would do

Probably charge you the same price but would save you the time of removing them

[BTLowry]

Quick google search is your friend

http://lindevineyardsupply.com/product/1-25-t-post-no-spade-no-paint/

[jason86]

I don’t know where you are located but I carry them at my store Ram Tool. We have locations in dfw, Houston, Austin,San Antonio , and corpus

[frios]

found them at MG building supplies in SA

[bigbad243]

found them at MG building supplies in SA

If you don’t mind, how much were they and what lengths did they have?

[LoneStarCarnivo]

We get them from Hill Country Hardware in Junction.

[Dusty Britches]

I don’t know where you are located but I carry them at my store Ram Tool. We have locations in dfw, Houston, Austin,San Antonio , and corpus

There you go!