Reply
Go Back   TexasBowhunter.com Community Discussion Forums > Topics > Equipment and Tuning
 
Thread Tools Display Modes
Old 02-02-2021, 06:49 AM   #1
BillyJack1975
Spike
 
BillyJack1975's Avatar
 
Join Date: Dec 2020
Location: Harlingen TX
Hunt In: Deep South Texas, Alaska
Default Heavy points and inserts

I know this has been beaten to death, so Iíll be brief. Iím hunting with 45-50# traditional bows and have been contemplating using heavy inserts to accompany my 145 grain broadheads. Iím using Gold Tip traditionals and have a question regarding gluing the inserts and tuning my broadheads. What glue is everyone using for their inserts nowadays? Iíve always used Fer-L-tite on aluminum without an issue , but on carbon shafts Iíll have to heat up the inserts to tune the broadhead.

Will a hot melt glue gun work to secure inserts, and will a hair dryer work loose up inserts to turn broadheads?

Was thinking of using my Fer-L-tite and just using a hot field point to turn the inserts as needed to align my 2 blade broadheads.
BillyJack1975 is offline   Reply With Quote Back To The Top
Old 02-02-2021, 10:19 AM   #2
jpdarby2
Spike
 
jpdarby2's Avatar
 
Join Date: Feb 2020
Location: Houston, TX
Hunt In: Texas
Default

I use bohning ferr-l-tite on my easton axis 5mm with 125 grain Ethics adjustable outserts with 125 grains tips with zero issues. I do however use Easton Hit Insert Epoxy on my hunting arrows for a little extra strength.
jpdarby2 is offline   Reply With Quote Back To The Top
Old 04-24-2021, 01:15 PM   #3
Bowhunter1994
Ten Point
 
Bowhunter1994's Avatar
 
Join Date: Aug 2012
Location: Rio Grande Valley
Hunt In: Anywhere I can
Default

I use kimsha glue, works great on everything Iíve used it on. Pulls out when you need it to. I use lighter, you can also use boiling water method


Sent from my iPhone using Tapatalk
Bowhunter1994 is offline   Reply With Quote Back To The Top
Old 04-25-2021, 06:18 AM   #4
SJP51
Six Point
 
SJP51's Avatar
 
Join Date: Jan 2021
Location: Nacogdoches
Hunt In: Menard, Nacogdoches, Bryan
Default

I use "cool melt" glue. It's a blue colored stick that melts (as the name implies) at a lower temp than fer-L-tite. Holds just as well.

To remove an insert, you just put a field point in and apply heat to the insert. The cool melt comes loose quickly compared to fer-L-tite and so helps not to overheat the carbon shaft.
SJP51 is offline   Reply With Quote Back To The Top
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:55 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
Copyright 1999-2012, TexasBowhunter.com