Helical on blazers

[public]

I use a bitzenburger straight clamp to fletch my blazers. I can get a pretty good offset/helical just by adjusting it. How much more helical can I expect, if any using the helical clamp on the blazers? Didn't want to buy the clamp if I'm getting all I can get now?

[hoyt21]

You'll get more than a off set with a arizona ez fletcher. That what I use right helical

[muddyfuzzy]

an arizona will give you a 6 degree helical, its pretty aggressive.

[hoyt21]

This is from a arizona

[public]

You'll get more than a off set with a arizona ez fletcher. That what I use right helical

I have an Arizona straight fletch. I could get the helical limbs for it but I really like using the bitzenbuger.

[public]

This is from a arizona

That looks about what I'm getting now...

[JW]

I get 6 degrees on my blazers.

[gatt40]

I was using the Bitz until recently. Now I use the E-Z mini & besides getting all the fletching done at once, it puts one heck of a helical to the vane

[Terry]

Same here, Arizona E-Z fletch for a great helical. Best I could get on Blazers on a Bitz was a fair offset.

[Pushbutton2]

Does the 6° offset help?

[Kimble.270]

Arizona E-Z fletch works great

[BTLowry]

Not sure but I think I was told 6deg was about as much as you could put on blazer type and still get good contact.

Not sure Bitz will give 6deg but it will probably get close

Dad has a Bitz but I have no idea how to measure the deg helical it can put on a vane

[JimGates]

Following....

[popup_menace]

Tagged

[popup_menace]

Here is what my Arizona does with blazers....



Hard to beat that helical, and I've never had a contact problem.