Reply
Go Back   TexasBowhunter.com Community Discussion Forums > Topics > Equipment and Tuning
 
Thread Tools Display Modes
Old 02-13-2020, 08:09 PM   #1
Black-N-Red
Ten Point
 
Black-N-Red's Avatar
 
Join Date: May 2016
Location: Weldon,Tx
Default Kentic Pierce

Is there some outsert that will fit the Gt Kentic Pierce arrows?? Iíve been using the factory inserts & collars but they just ainít worth anything!! Iíve used jb weld, hot melt, super glue & epoxy, the insert just donít stick with anything Iíve used.

Outer diameter is .245, inner diameter is .166

Thanks


Sent from my iPhone using Tapatalk
Black-N-Red is offline   Reply With Quote Back To The Top
Old 02-14-2020, 09:05 AM   #2
kd350
Ten Point
 
kd350's Avatar
 
Join Date: Jun 2011
Location: houston
Hunt In: Regan wells, fedor, paige
Default

Pretty sure the iron will hit insert system and collar will fit. That’s odd nothing will stick, not even jb weld. Dumb question, but did you scuff your the inside of the shaft then clean?
kd350 is online now   Reply With Quote Back To The Top
Old 02-14-2020, 09:38 AM   #3
Low Fence
Pope & Young
 
Low Fence's Avatar
 
Join Date: Aug 2008
Location: Quitman, Tx.
Default

Scuffed, cleaned and epoxy didn’t stick?
Low Fence is online now   Reply With Quote Back To The Top
Old 02-14-2020, 11:27 AM   #4
Black-N-Red
Ten Point
 
Black-N-Red's Avatar
 
Join Date: May 2016
Location: Weldon,Tx
Default

I cleaned scoffed with sand paper, cleaned again will acetone. Yesterday I was shooting into my bag target once the arrows pass through the burlap in the target when pulling them out the insert just pull right off.


Sent from my iPhone using Tapatalk
Black-N-Red is offline   Reply With Quote Back To The Top
Old 02-14-2020, 02:43 PM   #5
muddyfuzzy
Pope & Young
 
muddyfuzzy's Avatar
 
Join Date: Aug 2011
Location: gulf coast
Hunt In: Parts Unknown
Default

2-part/slow cure epoxy is the only way to go with outserts. I prefer AAE myself .


Sent from my iPhone using Tapatalk
muddyfuzzy is offline   Reply With Quote Back To The Top
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:23 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright 1999-2012, TexasBowhunter.com