Ok I have a queation for you guys.
I was wondering you know as you bare shaft tune you may need to cut your shaft a couple of times to get the correct length correct? Ok well I have been heating the half outsert I have been using just enough to remove the insert cutting the shaft then regluing my insert in. Ok what is wrong with just removing g the nock an trimming the nock end of the arrow instead? Would that make a difference in anything? I'm just curious sure would seem alot easier
I like shooting bare shafts it's a challenge for me.
An newman if I have asked you this an you have answered this or told me this sorry I have a short memory lol
I was wondering you know as you bare shaft tune you may need to cut your shaft a couple of times to get the correct length correct? Ok well I have been heating the half outsert I have been using just enough to remove the insert cutting the shaft then regluing my insert in. Ok what is wrong with just removing g the nock an trimming the nock end of the arrow instead? Would that make a difference in anything? I'm just curious sure would seem alot easier
I like shooting bare shafts it's a challenge for me.
An newman if I have asked you this an you have answered this or told me this sorry I have a short memory lol
Comment