Sight adjustment question.

[Bulldog7906]

Put a new sight on my bow and had questions on adjustments. I plan to sight the 20 yard pin by adjusting the housing. The adjust the following pins from the 20 pin.

Should I leave the 20 pin in middle like it came or move it all the way up before adjusting? See picture.

[HeyMikey]

I would personally leave it closer to the middle (prob just above), unless you run out of room for your pin gaps.

[Bulldog7906]

Ok thanks

[HighwayHunter]

Leave it in the middle. Low light conditions and no reference area above the pin to let light in make it hard to see. You’ll cover the deer up with pins and will have trouble with your FOV


Sent from my iPhone using Tapatalk

[muddyfuzzy]

I set my 40 on a five pine just a little below Center. I like the balanced sight picture with that set up. At the end it really boils down to that, just preference really.


Sent from my iPhone using Tapatalk

[Bulldog7906]

So, I "bore sighted" the sight adjusting the siight housing to where the pins are over the arrow. The windage adjustment on the housing is now maxed out. If I need to adjust, how do I do it?

[HeyMikey]

PM sent