I wanted to put some rod holders on my 18ft Xpress but I didn't want to part with the $150+ to get decent ones. So I broke out the 4 inch PVC and the heat gun.
Cut 2 peaces PVC 3 inches long.
Cut a 1 1/2 section from one.
Drill 2 inch hole thru all in the other peace.
Heat the last 1 inch section of the one with the slot. Here I'm doing 2 at one time. Bend it inward a make a "e" shape.
Cut the peace with the holes thru one hole and about a inch above the other. Bolt the 2 together and they clip on and off the rail nicely without drilling a hole in the boat.
Sent from my SM-J737A using Tapatalk
Cut 2 peaces PVC 3 inches long.
Cut a 1 1/2 section from one.
Drill 2 inch hole thru all in the other peace.
Heat the last 1 inch section of the one with the slot. Here I'm doing 2 at one time. Bend it inward a make a "e" shape.
Cut the peace with the holes thru one hole and about a inch above the other. Bolt the 2 together and they clip on and off the rail nicely without drilling a hole in the boat.
Sent from my SM-J737A using Tapatalk
Comment