Kentic Pierce

[Black-N-Red]

Is there some outsert that will fit the Gt Kentic Pierce arrows?? I’ve been using the factory inserts & collars but they just ain’t worth anything!! I’ve used jb weld, hot melt, super glue & epoxy, the insert just don’t stick with anything I’ve used.

Outer diameter is .245, inner diameter is .166

Thanks


Sent from my iPhone using Tapatalk

[kd350]

Pretty sure the iron will hit insert system and collar will fit. That’s odd nothing will stick, not even jb weld. Dumb question, but did you scuff your the inside of the shaft then clean?

[Low Fence]

Scuffed, cleaned and epoxy didn’t stick?

[Black-N-Red]

I cleaned scoffed with sand paper, cleaned again will acetone. Yesterday I was shooting into my bag target once the arrows pass through the burlap in the target when pulling them out the insert just pull right off.


Sent from my iPhone using Tapatalk

[muddyfuzzy]

2-part/slow cure epoxy is the only way to go with outserts. I prefer AAE myself .


Sent from my iPhone using Tapatalk