I was replacing the limbs on my Bowtech Tribute. I either lost one of the plastic pads that go between the riser and limb or it was never there. I haven't called Bowtech but doubt a replacement is available due to the age of the bow. I could probably make one with a dremel tool but before I did I wanted to see if anyone has had the same problem and if there is an easier/better solution. I attached a picture, the pad is about 1 1/4" long and shaped in a half cylinder.
Announcement
Collapse
No announcement yet.
Need to replace Bowtech Tribute Limb Pivot Pad
Collapse
X
-
Originally posted by ken View PostI was replacing the limbs on my Bowtech Tribute. I either lost one of the plastic pads that go between the riser and limb or it was never there. I haven't called Bowtech but doubt a replacement is available due to the age of the bow. I could probably make one with a dremel tool but before I did I wanted to see if anyone has had the same problem and if there is an easier/better solution. I attached a picture, the pad is about 1 1/4" long and shaped in a half cylinder.Last edited by rocky; 09-16-2018, 11:11 AM.
Comment