Finishing a cabinet. Noticed a split down the grain in a corner. Seems to be about 1" long & 1" wide so far. Don't think it would be structurally unsound and it is on the bottom in a corner and not noticeable. Not a wide split, I can pinch it and close it up to where you can barely see it. First thought was to inject some glue into split and clamp it til it dries. But that would mean opening it up more and maybe making the split longer. If gluing I would think I would need a small needle and thin glue so as not to widen split even more. Would you worry about it or glue it? Your thoughts please.
Announcement
Collapse
No announcement yet.
Wood, fixing a split
Collapse
X
-
Pics? For about $5 you can buy a glue syringe - online or from a woodworking store - that should work well. (I have also used a syringe made for marinade injection.) Experiment a little first, you may have to thin the glue a bit. In most cases a properly glued/clamped crack will not be noticeable after it dries.
Comment
-
I have never been able to post pics, tried many times following instructions in help forum and never works. I will probably use medical syringe because I have them for my goats. Was thinkin super glue because it is thin and would work in the relatively small needle but have never used it on wood. Would it Work? If not, can you thin Elmers wood glue and it still hold?
Comment
-
It does not take much liquid to thin wood glue so mix in a little at a time. (use water or vinegar) Woodworkers do it in situations when the need longer dry-time. The bond may not be as strong as using full strength glue but from your description it doesn't sound like the repair is going to be under any load so it should be fine.
Comment
-
Update: Went to get the syringe and needle @ Angleton Feed store. Talking to the guy behind the counter about what I needed it for. Taking his advice,ended up using a 16 Ga. needle, Elmers wood glue soaked in hot water to thin it. Heated a quart of water in Microwave, immersing the glue in the hot water. Doing this twice thinned the glue enough to get into the syringe and inject it into the crack.It is drying as we speak. will re-visit tomorrow to see if it is dry
I want to thank all who replied this thread! Maybe the suggestions you guys gave will stick in the brain pan and I can use them later.
Ps : the people @ Angleton feed can and will work with you on things you may not realize. Great bunch of people.
Comment
-
Originally posted by locolobo View PostUpdate: Went to get the syringe and needle @ Angleton Feed store. Talking to the guy behind the counter about what I needed it for. Taking his advice,ended up using a 16 Ga. needle, Elmers wood glue soaked in hot water to thin it. Heated a quart of water in Microwave, immersing the glue in the hot water. Doing this twice thinned the glue enough to get into the syringe and inject it into the crack.It is drying as we speak. will re-visit tomorrow to see if it is dry
I want to thank all who replied this thread! Maybe the suggestions you guys gave will stick in the brain pan and I can use them later.
Ps : the people @ Angleton feed can and will work with you on things you may not realize. Great bunch of people.
Comment
-
Originally posted by dustoffer View PostAnother glue to try is the runny super glue---it will wick into the very narrow voids.
dhillis. yes, clamped it. Took the clamp off this evening and seems to be holding great. Thanks for all the replies!
Comment
Comment