I decided to go the longer route and sand in a couple days after the epoxy cures then lay glass. I could have done it all in one step but then I would have more faring to do afterwards.
Announcement
Collapse
No announcement yet.
DIY flats skiff
Collapse
X
-
Originally posted by Leonhogboy View PostComing along nicely sir.
Thank you so very much my friend!
Well, I thought I would spend the morning removing blush from the epoxy and prep the hull for glass. Mother Nature blew another cold front in late last night/early this morning and the epoxy is not fully cured. Fortunately I am not in a rush but I was looking forward to getting some work done today. More than likely I will wait until Friday and check her again.
Comment
-
Originally posted by Brazos Hunter View PostI ran out of fumed silica to make thickened epoxy so unfortunately work has stopped for the day. More will arrive tomorrow but in the meantime I mocked up the trim tabs just because.
How do those tabs work for when you go in reverse?
Sent from my iPhone using Tapatalk
Comment
-
Alright, Spring Break is over and we returned home to the chaotic mess at the grocery stores and society. This morning we worked in the garden and this afternoon I got back on Project Skipjack!
First I wrapped up sanding then started laying out fiberglass. This build and one more will make two boats I’ve built so to say I was a little apprehensive about the glass work would be an understatement. It was a little stressful because I could feel the resin starting to flash just before I wrapped up with the sides but I was able to get it knocked out...both sides are now in glass!!! Tomorrow I will glass the bottom of the hull before going back to work.
Comment
-
Well, Spring Break is over and it is sadly time to return to the chaotic reality of society today. With the CDC recommending people to remain isolated if possible, I escaped to the shop and got back on Project Skipjack.
Glassing solo I had to get a little creative so I had to work the bow section first then slowly worked my way back. After lunch I will install the strip down the center then jump on the spray rails.
Comment
Comment