I reckon centershot doesnt matter. Rest is maxed right. Sight is maxed right. Bareshafts hit 6” high vs fletched shafts at 30 yards, fly nock low and nock left.
Muzzy 3 blades hit where I want...out to 30 yards. Muzzy 4 blades plane right.
I specifically asked Tech for my rest not to be hokey pokied (I had done that already) and bow tuned. And was told upon retrieval...“Since tears were only left and right not up and down...cables didnt need to be adjusted...just the rest.” I never saw paper tears.
Axle to axle spec is 33 13/16 with 1/8” +\- tolerance...current actual is 34”... Can I simply turn a limb bolt to bring to spec measure length? Both limb bolts are bottomed out for max poundage.
Darton 3800 31”
Any constructive suggestions would be appreciated. Ive already asked one archery buddy and he said “Firstly...why is all that crap on the right side of the riser?”
Muzzy 3 blades hit where I want...out to 30 yards. Muzzy 4 blades plane right.
I specifically asked Tech for my rest not to be hokey pokied (I had done that already) and bow tuned. And was told upon retrieval...“Since tears were only left and right not up and down...cables didnt need to be adjusted...just the rest.” I never saw paper tears.
Axle to axle spec is 33 13/16 with 1/8” +\- tolerance...current actual is 34”... Can I simply turn a limb bolt to bring to spec measure length? Both limb bolts are bottomed out for max poundage.
Darton 3800 31”
Any constructive suggestions would be appreciated. Ive already asked one archery buddy and he said “Firstly...why is all that crap on the right side of the riser?”
Comment