Hybrid Knife Scales

[Bjankowski]

I think the pressure pot must make the difference. I suspect the ones I made were just done with vacuum, and no pressure, so it didn't get good penetration.

Also, I kind of like the outside of the cone to be on the outside of the knife instead of the inside. I made one knife that looked like a fish. The pine cone looked like fish scales. It was pretty cool.

Sam with the Alumilite Epoxy Resin I use a vacuum will not work, they have to have about 45 -50 pounds of pressure, I leave them in pressure for at least five hours. Pine combs have too many voids that need the pressure and get rid of the bubbles.
Here's on I finished this morning.

[SamHarper]

It sure is pretty!

[COACH_EM_UP]

I will take the first one in the first picture. Take my money. VENMO or check.

[Bjankowski]

I will take the first one in the first picture. Take my money. VENMO or check.

Sorry bro, all those knives were sold. I don't sell on here very much anymore, I occasionally put one on here every now and then. I'm pretty busy these days, I make and sell over 300 knives a year.