Did you notice much change in point of impact, with / without suppressor?
In this case it was about 2-1/2” low and right at 100 yds. with the can. Consistently through multiple removals and replacements of my Rugged Razor 7.62 with a quick disconnect system.
There will be a shift in POI. How much depends on several things. Your barrel contour, length of barrel, caliber, which can you’re running, etc. Two of the same rifles with the same suppressors side by side may have differently POI changes. If you’re running a good setup, this shift should be repeatable though. I run an Omega direct thread on multiple rifles. They’re all zeroed with the suppressor, and I have no issues with POI shift when swapping the can back and forth. I can’t remember what my actual shifts were prior to zero (it’s written down somewhere), but they were all low. Roughly somewhere between 2-4”~ at 100 yds on average if I remember correctly.
Comment