View Single Post
Old 05-14-2019, 12:29 PM   #13
Ten Point
texan4ut's Avatar
Join Date: Jul 2014
Location: Round Rock, TX
Hunt In: Where I can, Terrell County

I have a question for the welders on here. My blind build will be in 4 sections and a roof. The blind will be transported to the site then each wall will be put up and bolted together. My problem is when the panels are fitted together I will not have access to the bolt head as it will be covered with insulation & R-panel I could cut an access hole to the blot hole and use a extension on a ratchet to tighten the bolt, or I was thinking of welding the bolt on then just slip the other panel on to the bolt and tighten. What do you guys think.
Attached Images
texan4ut is offline   Reply With Quote Back To The Top