I am struggling trying to bareshaft tune my bow. I went to the bow shop and tuned up my bow. When I left, I had sent a bare shaft thru paper three times in a row and achieved a pretty good bullet hole at 5 steps. I’m trying to build a new set of arrows but now every arrow I shoot into my foam target is pretty severely tail right. I shot thru paper again at my house and no matter which direction I orient the nock, I am always nock right tear. I can’t figure out whether the tune is my bow or an under spined arrow. My arrows were built using archers advantage software and they are supposed to be perfectly spined for my specs.
I then backed up to 30 yards and tried grouping with a fletched arrow. It groups close (four inches) but the nock is severely right into the target. The flight of the arrow just isn’t good enough out of my bow.
What steps would you take to move forward? What would you do to remedy the problem?
Sent from my iPhone using Tapatalk
I then backed up to 30 yards and tried grouping with a fletched arrow. It groups close (four inches) but the nock is severely right into the target. The flight of the arrow just isn’t good enough out of my bow.
What steps would you take to move forward? What would you do to remedy the problem?
Sent from my iPhone using Tapatalk
Comment