Chk jagerwerks, primary machine and impact machine. All top notch. I havnt checked recently but turn around is typically not bad.
Jagerwerks did my p10c, will prob have impact machine do my CZ PCR
Maple leaf in Celina is great. That’s where I took my P365 since he’s just 5 minutes from me. If you are around DFW and take it to him in person, he may be able to do it right then if you talk to him ahead of time. He did for me. Got to see the whole process and bs with him.
I'm getting my G20 cut and getting a HoloSun installed, it should be ready on Tuesday. I'll post pics when I get it. I'm getting it done at Ronin Armory here in Laredo.
Update on the optic cut:
I sent the new P365 slide off to Maple Leaf Firearms (Celina, TX) for the optics cut.
The setup and order operation of M.L.F. is nicely done, as I received email notices at each stage of the order and I could log onto their website and see the updated info.
While the MLF website indicated estimated 2-3 week turnaround for optic cuts (no refinishing), my slide took 4 1/2 weeks. It was right during archery deer season, so I think I can give them some consideration there, ha ha.
The packaging that my slide was returned in was really nice! Custom cut foam in the box to fit the slide, and a notice included with the screws about which driver to use for correct fit.
The machining looks cleanly executed, and the fit of the optic was very exact in the machined slide.
Threads were clean, and installing the optic was easy.
I am very pleased with the whole project and I'd recommend Maple Leaf Firearms.
Comment