Announcement

Collapse
No announcement yet.

Feeder Problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Feeder Problem

    I have the Buccees All Season stand and fill. It wasn’t spinning. I replaced the timer and put a new battery on it. It spun once but real slow. Tested again and it barely spun. 3rd test on and nothing happens. Any ideas?

    #2
    I have to ask was the new battery charged before you put it in?

    Comment


      #3
      Can you spin the plate freely?
      We had a couple of similar issues.
      1 was bad timer the other was stuck spinner plate

      Comment


        #4
        Originally posted by jjam View Post
        I have to ask was the new battery charged before you put it in?

        Yes. Tried multiple batteries and confirmed they were charged

        Comment


          #5
          bad motor maybe?

          Comment


            #6
            is the plate loose on the shaft? check the set screw to make sure it is tight

            Comment


              #7
              Originally posted by waterdog View Post
              bad motor maybe?
              This.

              Comment


                #8
                Check k the wires also. The area that go through the guard. I had 1 a couple weeks ago rub through

                Comment


                  #9
                  Check and see if you are getting voltage to the motor when itsturned on

                  Comment


                    #10
                    Originally posted by waterdog View Post
                    bad motor maybe?
                    I'd say bad motor. I had a similar problem once. Pulled the motor and checked it out. All rusty inside. Clearly, somehow, had been underwater at some point.

                    Comment


                      #11
                      Go straight from battery to the motor and that will tell you motor or not.

                      Comment


                        #12
                        Its the motor. I've had to replace a couple of them. Think its another design flaw of those feeders. All the pressure pushing down on it wears them out faster.

                        Comment


                          #13
                          Originally posted by luv2hunt View Post
                          Check k the wires also. The area that go through the guard. I had 1 a couple weeks ago rub through

                          This. I had a hog push the wire cover and pinch a wire.

                          Comment

                          Working...
                          X