Project wheel bearing

[Bh_liberty]

Anyone???


Sent from my iPhone using Tapatalk

[GOODEN]

Take a small prybar and get between it and rear end and pry out on it. Go from one side to the other then rotate it. If it’s never been out, it may take a lil bit. When installing new one put a lil grease or never seize on it.

[Bh_liberty]

Take a small prybar and get between it and rear end and pry out on it. Go from one side to the other then rotate it. If it’s never been out, it may take a lil bit. When installing new one put a lil grease or never seize on it.

Thanks


Sent from my iPhone using Tapatalk

[175gr7.62]

Any of y’all got a suggestion on how to get this out?




Sent from my iPhone using Tapatalk

Crows foot or a small pry bar alternating sides. The ring on the end of the shaft sometimes gets fussy. It will come out.

Grease the shizznit out of it when you put it back in.


Sent from my iPhone using Tapatalk

[Bh_liberty]

Crows foot or a small pry bar alternating sides. The ring on the end of the shaft sometimes gets fussy. It will come out.

Grease the shizznit out of it when you put it back in.


Sent from my iPhone using Tapatalk

Thank you sir


Sent from my iPhone using Tapatalk

[DoubleGG]

If the above doesn’t work. There is a vise grip with a with a weighted sledge set up that will come out very easy. I have a screen shot but can’t get it to upload. Should be able to get it out in seconds with it without messing up the housing.

[DoubleGG]

I can text the picture to someone to load it you would like.