I've been wanting to make a cooler spacer to keep meat out of the melted ice and also keep the drain plug clear so water drains. I was thinking about taking a piece of UHMW and cutting it to fit the bottom. I figured to screw 1.5" UHMW blocks to all corners and some in the middle to space it up off the bottom. Drilling holes through out the top would allow the water to drain down.
Any thoughts?
I figured 1/4" UHMW for a top and 3/4" thick to make the blocks out of.
Any thoughts?
I figured 1/4" UHMW for a top and 3/4" thick to make the blocks out of.
Comment