Originally posted by Kevin
View Post
Announcement
Collapse
No announcement yet.
Automatic gate openers recommendation
Collapse
X
-
Originally posted by Kevin View PostI have a Ghost Controls and it’s awesome. Easy install and opens every time.Originally posted by Biggs View PostThis. Zero problems so far.Originally posted by Rubi513 View PostI have the ghost controls and it’s been flawless since I got it 3 years ago.Originally posted by Gladesgator View Postx2
Comment
-
US Automatic Patriot for me. I did the 110V with battery backup and it has been great going on 4 years. Use good quality geaseable hinges so your opener's job is easier. The only compliant I have is their manual for installation of the automatic exit sensor is less than great but I figured it out eventually.
Comment
-
Originally posted by Dusty Britches View PostI looked at Ghost Controls and they are not priced all that high.
Turns out that my gate problem was a bad battery. It won't hold a charge. New battery and we are all good again.
That was my problem with my MM 350.? had issues opening and replaced battery and no issues since . Its going on 5-6 years on a fairly light 18' gate... gate is too big BUT wont replace until I have to. I did have some water issues early on as well BUT took apart and small bead of silicone at seam fixed that
Comment
-
Yes, it seems to get a lot of water in there. The entry port for the lines is open and allows water in. Poor design. I broke the seal and put a bead of grease around it because at the time that's all I had. Dern carpenter ants were getting in there, too, but the same grease on the lines going in stopped them from doing that.
Comment
-
Originally posted by Wall_Hanger View PostUS Automatic Patriot for me. I did the 110V with battery backup and it has been great going on 4 years. Use good quality geaseable hinges so your opener's job is easier. The only compliant I have is their manual for installation of the automatic exit sensor is less than great but I figured it out eventually.
The exit sensor was easy for me. The safety beams and correct programming is what I had to get on a tech support call for.
Sent from my iPhone using Tapatalk Pro
Comment
Comment