View Single Post
Old 04-25-2019, 10:30 AM   #1
Ten Point
texan4ut's Avatar
Join Date: Jul 2014
Location: Round Rock, TX
Hunt In: Where I can, Terrell County
Default The adventure begins. Blind build

Going to build a 6x6 rifle blind. 1" 14ga square tubing frame. It will be on a 8 foot tower. I am a novice when it comes to welding so not sure how it will turn out. As they say the turtle only makes progress when he sticks his neck out. This will be built in 4 sections so I can lift one section/side up bolt it down then lift up the next bolt it down and to the 1st. I will most likely be putting it on the tower by myself so this is the best way I think to do it. Any suggestions will be appreciated. I have the frame squared up clamped down level, corners cleaned and ready to stick it together.
Attached Images
texan4ut is offline   Reply With Quote Back To The Top