Custom Broadhead Adapters

[RickBarbee]

Friday, I picked me up a bench top metal lathe.

Finally got a chance to really do a serious project run on it today, and built a custom broadhead adapter for my Jerry Hill broadheads. The adapter is total glue in the broadhead/on over the shaft.

Took me three runs at it to get the measurements right, but it's there now, and I have all the measurements written down, so it will be easy to duplicate.

Fit's onto the shaft "exactly" like the stock outserts.

Darn solid hook up.

Rick

[RickBarbee]

Glued into broadhead, and onto shaft.
Spin Test.

Not perfect, but plenty good enough.
In the quiver, and ready to rock.

https://rumble.com/v2in7z8-lathe-built-glue-on-broadhead-adapter.html

Rick

[DRT]

The pics we need are of it with a dead animal.

Sent from my Nokia XR20 using Tapatalk

[RickBarbee]

The pics we need are of it with a dead animal.

Sent from my Nokia XR20 using Tapatalk

That would be nice, but pigs aren't showing up here at the home place, and I haven't got things settle enough (yet) to start hunting over at the farm again.

Rick

[DRT]

Yeah I'm not even sure I can remember how to get to our place it's been so long.

Sent from my Nokia XR20 using Tapatalk

[RickBarbee]

This one was made with drill bits a little to large.
Only ones I could find in town.

I've found the right size bits now, and will order them in, and this thing will really spin true when built with them.

Rick

[RickBarbee]

Made a new one with the correct drill bit sizes.

I'm going to continue using the 8/32 all-thread for the pin. It works just fine, is readily available, and easy to work with.

I do believe I've got it nailed down, because this one works darn good.

Rick

[RickBarbee]

And, the spin test video.

This is just with it all slipped together, but not glued.

https://rumble.com/v2j2vc6-homemade-broadhead-adapter-take-two.html

[Pvrana]

Looking good Rick -- cool looking Broadhead