Hey Y’all good morning. I recently have gotten some two blade buzz cut broad heads. I have heard different opinions on if you should or should not index but I was wandering what some of y’all’s opinions were on the topic, and if you could share some of your experiences and how y’all do it.
-
-
I build my own arrows from the shaft up. I make sure the arrows are squared on both ends and install the insert. I'll screw in my two blade buzzcuts and spin to make sure insert is square and broadheads are not wobbly. I then shoot the bareshafts with field points and index the nock. Once my nock is indexed I'll mark the arrow at the nock. I'll then fletch the arrow and compare on target with field points. I have yet to index a broadhead, since I had initially done it in the past, and it has made zero difference whether or not I did it. None of my broadheads/fletchings are in the same sync as the next arrow beside it, unless it just ends up that way. Your buzzcuts are great. Indians brought down buffalo with the very same design, except that now, it's the very same design, but in steel form. [emoji123][emoji16].
Sent from my moto g(6) using Tapatalk -
Never haveComment
-
Don't even know what you are talking about- please explain. I may do it and just call it something else !Comment
-
NOpeComment
-
Nope. I tune my bow and all my arrows bare shaft so no need in worrying bout that.
Sent from my SM-G892A using TapatalkComment
Comment