Dang, was wondering where I could mount my feeder to the front of this thing. Didn’t want to put it in the back receiver hitch because it’ll be too low. Lots of plastic up front though. The only metal I could make use of was the pipe on the bumper, but that’s thin. Ok, there’s the winch faceplate I can also use for support and the light bar mounting holes on top of the bumper can be put to use too to stabilize it. Welded the 2” receiver sleeve on a piece of 3” flat iron. Welded that on to the bottom pipe of the bumper and supported it to the winch faceplate with 3/16” x 1” angle iron. Plenty support now. Made a brace for the back of the feeder with angle iron and 1 1/2” flat bar to mount to the light bar holes. Worked out great. I drove around and hit every bump on purpose and no rattling whatsoever. I only took a few pics because I was in thinkin mode. Lol
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Comment