I am about to start rebuilding all my feeders to stand and fill. I have been looking at some DIYs and info on here and its what I need..
question 1 what size square panel should I use?? and what radius if any dose it allow the corn to sling?
#2 how high is everyone making them I was thinking the top lid to be about 6.5-7ft,( I'm 6.1 for referance) I was thinking about going a bit higher and welding in a small step but that might defeat the whole idea... what yall say???
question 1 what size square panel should I use?? and what radius if any dose it allow the corn to sling?
#2 how high is everyone making them I was thinking the top lid to be about 6.5-7ft,( I'm 6.1 for referance) I was thinking about going a bit higher and welding in a small step but that might defeat the whole idea... what yall say???
Comment