Next question is on barrels. Is it worth going with a Proof carbon barrel or just stick with a quality made steel? I know steel barrels are half the cost but I want to take my time and build this up right
Go Rainier UltraMatch for your barrel. They’ve been spinning them off Rock Creek blanks for some time. Everyone I’ve seen has been a hell of a shooter. I’ve got a 17” SPR 223 that I’ve taken out to 970 without issue. May try and stretch it past 1000 here in an hour.
Love my grendel and my valkyrie it's to shabby either. Check out airborne arms if you go with the 224. Pretty good clip on the 224 on YouTube under, "is the 224 valkyrie dying off?"
Go Rainier UltraMatch for your barrel. They’ve been spinning them off Rock Creek blanks for some time. Everyone I’ve seen has been a hell of a shooter. I’ve got a 17” SPR 223 that I’ve taken out to 970 without issue. May try and stretch it past 1000 here in an hour.
That not too bad on the price compared to the Proof barrels I was lookin at!
Next question is on barrels. Is it worth going with a Proof carbon barrel or just stick with a quality made steel? I know steel barrels are half the cost but I want to take my time and build this up right
Hell of an expense (~$900) for a gas gun barrel, I've done it on a bolt action and would do it again, but wouldn't personally on a gasser. Plus you'll be limiting yourself to 0.875" gas blocks, of which there are significantly fewer options.
If I was going to spend money on an AR barrel, I'd get a Bartlein:
Hell of an expense (~$900) for a gas gun barrel, I've done it on a bolt action and would do it again, but wouldn't personally on a gasser. Plus you'll be limiting yourself to 0.875" gas blocks, of which there are significantly fewer options.
If I was going to spend money on an AR barrel, I'd get a Bartlein:
and use the savings to buy the nicest trigger I could.
I think you may be right. I sat with the Proof guys today at DSC for a bit and they were going over stuff with me. After their feedback and ideas I like the carbon barrels for a 28nosler or 280ai build but am gonna go with quality steel barrel on the grendel
Hell of an expense (~$900) for a gas gun barrel, I've done it on a bolt action and would do it again, but wouldn't personally on a gasser. Plus you'll be limiting yourself to 0.875" gas blocks, of which there are significantly fewer options.
If I was going to spend money on an AR barrel, I'd get a Bartlein:
This listing is for Barrel and Bolt Only!!! 6.5 Grendel Bartlein Cut Rifled Barrel 5R Rifling 1-8 Twist Stainless .720 Muzzle target crowned .750 Gas Block - Medium HBAR Profile Rifle Gas System PF Bolt matched to barrel by us Chambered in house to extreme match specifications Test Fired with 3 rounds Options: Fluted with 6 flutes Front and Back sections inhouse by PF Fluted with 8 Flutes Front and Back Threaded 5/8x24 Lead time Uppers get are 6-8 weeks, Barrels are 10-12 weeks.
and use the savings to buy the nicest trigger I could.
I have one of these barrels and I’m not real impressed with it. So far my Alexander Arms barrel was more accurate.
I’m considering a Proof barrel to replace it with.
That not too bad on the price compared to the Proof barrels I was lookin at!
Wind sucked yesterday. I played at 800 and in. It did it’s part. Wasn’t quite as accurate as id like, but I knew that might be an issue dropping from a 3-15 precision optic to a 1-8 LPVO. I could still hit with reasonable accuracy, but not quite as easily and accurately as with a better suited optic. The reticle was the main hurdle.
Comment