What angle on pipe for legs on fire pit?

[BLAKJAX]

pic. of one I built an sold to a TBH member

[Bucksaw]

Cut one end at a 90 and the other at about a 15. Put the 90 against the end cap ad weld it on so that the 15 sets flat on the ground.

I have one exactly like what you are talking about at home except mine has legs made from 2 1/2" quarter wall square tubing. It was from some scrap we had and the ends of the legs were capped already. I just left a 90 on it and figured it was good enough. Works great. Having an angle cut on the bottom would just be for looks anyway.

[Bucksaw]

15* is the same angle as I use on Deer Feeder legs

We use it for stands too.

[JES]

Cut one end at a 90 and the other at about a 15. Put the 90 against the end cap ad weld it on so that the 15 sets flat on the ground.

Bingo!