Asf ez-feeder

[GWilly]

Does anyone know of a Bucee's around Houston with these currently?

[HeyMikey]

Does anyone know of a Bucee's around Houston with these currently?

Do any of the Brazoria county stores have them?

[dustinztx]

I put mine out today and I have to safe I a pretty impressed for the cost. I also cover the motor with a 6" exhaust vent and sprinkler cover. Worked like a champ.

[BBD]

Do any of the Brazoria county stores have them?

Not that I am aware of. I got mine at the Waller store. Wharton may, but I didn't see any during early part of dove season.

Sent from my SAMSUNG-SM-G891A using Tapatalk

[Red Man]

Does anyone know of a Bucee's around Houston with these currently?

I saw several at the waller store yesterday.

[Smart]

Any problems with these leaking at any seams yet like the old AllSeasons feeders?

[BBD]

Any problems with these leaking at any seams yet like the old AllSeasons feeders?

Not yet, Hopefully not.

Sent from my SAMSUNG-SM-G891A using Tapatalk

[sotol]

Plus few sheet metal screws

Did you get the cap at HD also?

Sent from my LG-K550 using Tapatalk

[axisbuck]

Does anyone know of a Bucee's around Houston with these currently?

Saw one in Baytown one yesterday

[dustinztx]

Got mine all setup and motor covered last weekend.

[Hendo]

Picked one up from Temple yesterday. Hoping to get it out today or tomorrow. Need to grab a 12V battery.


Sent from my iPhone using Tapatalk

How many did they have in Temple?


Sent from my iPhone using Tapatalk

[dustinztx]

How many did they have in Temple?


Sent from my iPhone using Tapatalk

They had 2 more when I picked up this one. Wish I could afford to buy them all.

[Hendo]

****... I can’t get there until Thursday


Sent from my iPhone using Tapatalk

[Hendo]

If anyone goes by Temple before Thursday let me know if they have any. I’d be much obliged!


Sent from my iPhone using Tapatalk

[offthemap]

I've got a review for you guys...

I picked up one of these from the Bucee's in Terrell this summer and put it out in Knox County. It was easy to set up and ran great for a few months but the last time we went out it wasn't throwing. After messing with batteries, swapping timers, etc., I figured out that the large "varmint-proofing" plate that sits under the spinner needs to be adjusted down about another 1/2-3/4" away from the base of the feeder box. This will prevent the spinner plate from letting the corn kernels get jammed up between the plate and the bottom of the feeder. I think this is mostly due to the weight of all the corn on the bottom of the feeder box and lack of support.. otherwise when full it will bulge/swell enough to get the spinner plate & corn in a bind.

Not sure how long my feeder was locked up but I think I've realized the biggest design flaw with these cheaper ASF stand & fill feeders. I plan to replace the bolts holding the plate with some that don't have the sleeves (threaded 100% of the shaft) and add 2 nuts to act as spacers.

Anyone else run into this issue yet?