About to start on this one. Hard to tell from the pic, but there is quite a bit of rust damage to the 7 gauge deck towards the front. Planning on coming back in with 10 gauge assuming the gearbox checks out. Speaking of the gearbox...it's a 125 HP box...on a 7ft shredder!
To do list:
- Change gear box oil
- Replace u-joints
- replace front deck
- paint
- If all goes well I might add a hydraulic cylinder for the rear wheel lift
- attempt to fabricate a new stump jumper as the current one is rusted out (part cost over $800 and I am trying to keep this under $400)
To do list:
- Change gear box oil
- Replace u-joints
- replace front deck
- paint
- If all goes well I might add a hydraulic cylinder for the rear wheel lift
- attempt to fabricate a new stump jumper as the current one is rusted out (part cost over $800 and I am trying to keep this under $400)
Comment