DIY bbq pit build.

[dpg481]

Got off a little early today and did some hole plugging. Got the plates for the holes cut ,welded, and grinder down. Also got me a smoke stack I'm going to try an get put in this next weekend if I don't get rained out.

[Txrdnk]

Looks good.

[macVsog]

Did you finish this yet? Looking good.

[dpg481]

Did you finish this yet? Looking good.

Man not even close. I've been doing some hog hunting and still need to get a trailer to set it on. I need to get motivated for sure.

[Fla Hunter]

Subscribed. Thus far its looking good man.

[Beerdonga]

looks great so far

[Fla Hunter]

Any updates?

[dpg481]

I've been a little stagnant on the build here lately, but today ui came across a trailer to put it on. Got the trailer home and so far I've got the junk cut off of it. Now I will be headed to the metal yard in the morning for some parts.

[TimA]

I wish I could do that.

[dpg481]

Well I got a pile of trailer guts on the ground and added some old spare camper spare tires I had and a new jack up front. After putting the wheels an tires on I figured out the trailer is way too tall so I will be doing an axle flip tomorrow before setting the tank on.

[dpg481]

Pic

[dpg481]

I got the axle flipped last night and it made a huge difference in the height. Now I'm adding the smoker supports and bracing the frame. Once that is done I will remove the factory cross braces that are a dead give away that it use to be the means of transportation for a boat.

[dpg481]

Almost ready to set the pit on it.

[Mike D]

That's going be a beast.

I saw this open pit while in Alabama this week.

[dpg481]

Now that's a lot of pig. I bet they know how to throw it down.