Setting up a new bow for my young boy.
20" draw dialed all the way down (maybe 15-20lbs)
I have the arrow passing thru the middle of the rest bolt hole, and rest and nock tuned so that it makes a clean center punch on the paper test.
My goal is to setup pins at 10 and 20.
Unfortunately, with this setup, I can only get the 10 yard pin to work if I have it all the way to the bottom of the sight, I am out of adjustment... so i can not get a 20 yard pin set up.
My options, as I understand them are, ....
1) raise rest
2) lower nock
3) raise peep
4) get a drop bracket for sight.
IMHO, option 1 or 2 would basically put the bow out of tune, so I really need to do 3 or 4.
Am I correct? Any suggestions / recommendations?
20" draw dialed all the way down (maybe 15-20lbs)
I have the arrow passing thru the middle of the rest bolt hole, and rest and nock tuned so that it makes a clean center punch on the paper test.
My goal is to setup pins at 10 and 20.
Unfortunately, with this setup, I can only get the 10 yard pin to work if I have it all the way to the bottom of the sight, I am out of adjustment... so i can not get a 20 yard pin set up.
My options, as I understand them are, ....
1) raise rest
2) lower nock
3) raise peep
4) get a drop bracket for sight.
IMHO, option 1 or 2 would basically put the bow out of tune, so I really need to do 3 or 4.
Am I correct? Any suggestions / recommendations?
Comment