Xj rear bumper build

[CoolArrow]

Jeep with stock bumper

Progress. Fab up the frame 2" square tube
Did this yesterday. Using all 3/16 steel. With swing-out tire carrier. Ordered a hinge assembly from comp 4x4 out of Utah


Sent from my iPhone using Tapatalk

[CoolArrow]

Got the top plate and lower hinge piece on today


Sent from my iPhone using Tapatalk

[CoolArrow]

Tire carrier hinge. This hinge is heavy duty well made. Shout out to comp 4x4 -Jason.


Sent from my iPhone using Tapatalk

[CoolArrow]

Making progress. Welding on the rear plate. Then up next will be the corner /end plates


Sent from my iPhone using Tapatalk

[CoolArrow]

I
Option 1

Option 2

Which do y'all think looks better?


Sent from my iPhone using Tapatalk

[Texar]

I'd say Option #2 just to protect the thin stuff. Lookin Good!

[WhiplashTX]

Option 1 unless your going to go play in the rocks.

Really? Busch tall boys?

[CoolArrow]

Option 1 unless your going to go play in the rocks.

Really? Busch tall boys?

Yup! .99 for 25oz can. this is my shop brew!

[CoolArrow]

I'm leaning towards option 1. My son says it looks too boxie. Thinking about angle down the corners. Not doing any rock climbing. Just my lease ride.

[WhiplashTX]

It's an XJ, the whole vehicle is a box.

[Humper]

Option 1 gets my vote

[CoolArrow]

Update. Bumper is complete. Next will be fabbing up tire swing carrier.



Sent from my iPhone using Tapatalk

[CoolArrow]

Sent from my iPhone using Tapatalk

[CoolArrow]

Tire carrier looks good.




Sent from my iPhone using Tapatalk

[kruppa24]

Looks good