Polaris Ranger A arm and Lift

[R Herline Jr]

I just ordered a 3'' A arm lift kit from Outkast Fabworx for my Ranger. It doesn't look that complicated. Have any of yall installed these yourselves? If so any pointers?
what not to do?
Any info would be HELPFUL

[Blue Tick]

I'm doing this to my Ranger soon as well. Good luck!

[Quackerbox]

I believe theres a few members who've done one form of these or another. Cant be that hard. Where you located Im fairly handy with tearing the hide off my knuckles and watching

[Beargrizzly90]

Never mind.. lol

[Rsp]

It’s pretty easy, most kits don’t come with new aarm bushings but a good knock with a hammer and they come out of the stock arms fairly simple. That’s about the hardest part, at least it was for me.

[jathomas437]

Pretty straight forward. Swapping out the ball joints is the worst part, but not bad with a vise or press.

[day0082]

If it is an older ranger and well used, ( the one i use to have 2011) I had to use a sawzall to cut the "A" arm bolts off and drive them out.

[rjbowmaster]

It was pretty simple, but I got my a arms with the ball joints already installed


Sent from my iPhone using Tapatalk