Found some scrap and decide to make a camp axe.
Cut out profile from 3/4" 316 stainless plate
LOTS of grinding!
Overlayed the tip with a harder weld metal
Cut out 18" handle from some 1/4" stainless plate, and welded on axe head
Filled up and ground down smooth from head to handle.
Handle material rough cut and ready for epoxy.
Finish sanding and coated with sealer
Cut out profile from 3/4" 316 stainless plate
LOTS of grinding!
Overlayed the tip with a harder weld metal
Cut out 18" handle from some 1/4" stainless plate, and welded on axe head
Filled up and ground down smooth from head to handle.
Handle material rough cut and ready for epoxy.
Finish sanding and coated with sealer
Comment