Bow mount. Suggestions please

[Krutch]

I recently bought a spy point Xcel camera to mount on my bow. Now the hard part is fabricating the mount that will go behind the stabilizer.

Also I saw on a posting of a stabilizer made of pvc which I'm interested in duplicating if anyone out there has instructions, it would be much appreciated.

Any ideas?

[Gummi Bear]

This should clamp to your stabilizer.

Easy and solid. I mount my GoPro with a similar mount.


"I went to the woods because I wished to live deliberately" - Thoreau

[Gummi Bear]

Or this'll work


"I went to the woods because I wished to live deliberately" - Thoreau

[Krutch]

Or this'll work


"I went to the woods because I wished to live deliberately" - Thoreau

Thank you. I saw this and may go that route. Not sure why but if I can make it ....

[2BigMethod]

Like this

[ATTACH]818771[/ATTACH]

[ATTACH]818772[/ATTACH]

[Krutch]

Like this

[ATTACH]818771[/ATTACH]

[ATTACH]818772[/ATTACH]

That's the one!

[2BigMethod]

They are pretty easy to make. I used 1" pvc with flat end caps, and 5/16 bolts fine thread (24 pitch i think) w/ nuts and get creative with it. I used flat washers for weights also had some inch thick neoprene gasket material here at work that i used for damping inserts. Drill whole for the 5/16 bolt in the end cap, may have to sand down the end cap so that it fits snug in the end of the pvc.

[2BigMethod]

Here is the front of the stabilizer, gasket material insert
[ATTACH]819634[/ATTACH]

[Krutch]

They are pretty easy to make. I used 1" pvc with flat end caps, and 5/16 bolts fine thread (24 pitch i think) w/ nuts and get creative with it. I used flat washers for weights also had some inch thick neoprene gasket material here at work that i used for damping inserts. Drill whole for the 5/16 bolt in the end cap, may have to sand down the end cap so that it fits snug in the end of the pvc.

Thank you so much!!!

[2BigMethod]

No probs

[Jerod]

That PVC Camera Holder came out pretty legit haha, very nice! I use a gopro Mount on mine, isnt the sleekest looking mount but she works.

[ryanc02]

I attached mine using a go pro mount to my top limb and it works for me