New Feeder

[Toolman]

My stand and fill project.

Sent from my SM-G965U using Tapatalk

[joel45acp]

Yup, built mine very similar. It works awesome. Good job

[progolferv1]

Looks great. Nice job

[RobinHood]

Nice [emoji1303]


Sent from my iPhone using Tapatalk

[RascalArms]

New Feeder

Looks good...hard to tell if it’s a 55 or 85gal barrel? Shed the ring with the bolt. They are a PITA! Replace with a good galvanized lid and Bob’s Your Uncle! [emoji108]

[Starvin]

x2 on the lid Nice job

[Toolman]

I like my design. I have found a flaw. The 1x1 wire is too small. it looks like a popcorn popper in the cage then it all falls under the feeder. Have to change that.

[Toolman]

Don't like this.

Sent from my SM-G965U using Tapatalk

[Oldblue]

Nice work, should work great for you. Good Luck!

[ByronB]

Good job. I had two of the bases built. One holds an 85 gallon drum and the other 55 gallon.

[Hammerdown]

Looks good...hard to tell if it’s a 55 or 85gal barrel? Shed the ring with the bolt. They are a PITA! Replace with a good galvanized lid and Bob’s Your Uncle! [emoji108]

I took your advice. I just finished 3 of them. All 85 gallon drums.



Sent from my iPhone using Tapatalk

[RascalArms]

I took your advice. I just finished 3 of them. All 85 gallon drums.

That’ll work Travis. You build good heavy stuff sir!!

[tdwinklr]

can't tell if there is a spinner or not, wouldn't the wire hinder the thrown spread?

Looks good though, need to build some like this.

[Bish]

If your spinner is not below your frame that will be what your corn is hitting and going straight to ground, that's what mine was doing and had to add a ext. to lower spinner, hope this helps.

God Bless
Bish

[RascalArms]

If your spinner is not below your frame that will be what your corn is hitting and going straight to ground, that's what mine was doing and had to add a ext. to lower spinner, hope this helps.

God Bless
Bish

Yup....I had to add a lower “downspout extension” of sorts to mine.