Assassin and Blazer

[AAJ]

Has anyone had an issue with the Blazer Vanes on there arrows contacting there cable on there BowTech Assassin. I am using the Easton Power Flight 400. I will send a pic later. I just wanted to see if anyone was having this issue.

[J Dub]

nope

[rocky]

If center-shot is set correctly, they won't come close.
Make sure your cable-rod has not backed out, as this is common on the Assassin.
I glue all cable-rods in prior to these bows leaving my shop.

[AAJ]

[ATTACH]376544[/ATTACH]

[kevin nicholls]

I shoot the same bow and blazers and it's not close. Maybe 3/8" clearance there on mine. I'd get that looked at by a pro. Good luck, Kevin

[AAJ]

[ATTACH]376571[/ATTACH]

[AAJ]

Going to a pro is the next step. just cking to see if anyone is having similar issues.

[AAJ]

If center-shot is set correctly, they won't come close.
Make sure your cable-rod has not backed out, as this is common on the Assassin.
I glue all cable-rods in prior to these bows leaving my shop.

It looks like the cable-rod had backed out. Thanks for the help rocky!!!

[bowhuntntxn]

You can also rotate the vanes around for clearance.

[ABroussard]

It looks like the cable-rod had backed out. Thanks for the help rocky!!!

This happened on mine. Started shooting all over the place.

[AAJ]

You can also rotate the vanes around for clearance.

I will do this for some additional clearance. Thanks.

[Csmith52779]

You can also rotate the vanes around for clearance.

I had to do this with my bow it wasnt a Assassin but it helped with clearance