I picked up a Dog chew from TSC for $3.
I looked for one that was as thick and flat as I could find. I cut the flattest side off and flatten it to a uniform thickness of about 3/16. Then I randomly jigged it with a Dremmel tool and charred it with a torch.
Here is a test I did on a sample piece.
Here they are mocked up on a knife I'm making for my brother.
And here they are almost done.
Hoggslayer
I looked for one that was as thick and flat as I could find. I cut the flattest side off and flatten it to a uniform thickness of about 3/16. Then I randomly jigged it with a Dremmel tool and charred it with a torch.
Here is a test I did on a sample piece.
Here they are mocked up on a knife I'm making for my brother.
And here they are almost done.
Hoggslayer
Comment