View Single Post
Old 12-11-2017, 12:28 PM   #8
texan16
Ten Point
 
texan16's Avatar
 
Join Date: Dec 2009
Location: Fairfield
Hunt In: Freestone/Schleicher Counties
Default

Quote:
Originally Posted by WBA2000 View Post
I use a bolt and a T-nut. Drill a hole large enough for a the T-nut to fit just in front of hole where spinal cord comes out. Put bolt thru from back of plaque and skull. Can be kind of tricky to line up T-nut and bolt but you can tighten down on it pretty good and it should not move.


I usually trim off one side to get the nut thru the spinal hole. And use forceps to insert and hold in position to thread the bolt in. Although I think I might start using all thread and a nut behind the plaque and cut it after it is tight to the plaque.
I use same idea but use a spring loaded toggle nut/wing nut. Works perfect.
texan16 is offline   Reply With Quote Back To The Top